TEMA:

Aciu, bet dar net neturiu ant rankų. Ryt poryt turi ateit.
Raportuosiu jumi asmeniskai ar patinka jis man.

Gerulis. Sveikinu su shirdziai maloniu pirkiniu!

Supratau, vadinasi be reikalo apsidžiaugiau Jau pradėjau su gunsmith'u derintis dėl ginklo parengimo, panašu kad planus teks atšaukti...

Na gauti pavyko labai lengvai- pinigus teko sumoketi ir viskas Nes gyvenu sauletoj Floridoj
Manau, kad legaliai įvežti ginklą į LT is US pakankamai sunku yra.

G17,

Jei nepaslaptis, kaip pavyko iš USA gamintojo gauti custom 1911? Ginklas atrodo fantastiškai!

Ash irgi nusprendzhiau paminet 100-meti
Gerai. kad zhmona nezhino uzh kiek pinigu ash ji paminejau

Heinie Rear, Brazzo fiber optic front, Larry Davidson Grips, Storm Lake Barrel, Caspian Carbon Steel Slide, Remsport Frame, and all Ed Brown, Wilson, and STI parts

Gamintojas- Lou ish Business End Customs

Žemai lenkiu galvą /thumbsup Pats šiuo metu planuoju praplėsti kolekciją Springfield Longslide /rockon

Harry Potter gauni karmos pliusa. aciu uz info. As zmona nuteikineju tam, kad teks siemet 1911 isigyti simtmecio proga :-D

Dabar aisku /thankyou

In light of new members comin' in who want to know what the differences are between the Series 80 Colts and the original design 1911s...

There are 4 additional parts...two in the frame and two in the slide.

Frame: Trigger bar lever and plunger lever.
Slide: Firing pin plunger and the spring that drives it.

There are also differences in some Series 80 parts. The parts that are modified are:

Grip safety...Firing pin...Firing pin stop...Extractor. All other parts are the same. The named Series 80 specific parts will work in Series 70 and pre- Series 70 pistols without modification, but not vice-versa unless the frame levers and the plunger and spring are removed from the Series 80 pistol.

The half-cock notch on the Series 80 hammer is also different, but all hammers
will physically interchange between the two designs. You can use a pre-80 hammer in a Series 80 pistol with the system intact. Likewise, a series 80 hammer will work in a pre-Series 80 pistol.

Swapping triggers between the two designs will physically work, but if the
bow is a little too short, the trigger bar lever may not move the plunger lever
upward enough to release the firing pin completely. There is a simple check
for that possibility in the event of a trigger change, and should be done
whenever a trigger is swapped.

Triggers with overtravel screws are also a potential trouble spot in a Series 80 pistol. If the trigger travel is limited to the minimum by the screw, the same
caution applies as above.

The difference in trigger pull between Series 80 and pre-Series 80 pistols is
negligible, assuming the same geometry and surface prep/finish on the related trigger group parts.

The Series 80 system does NOT make the pistol more safe to carry in Condition One, contrary to many widely-held mistaken beliefs. It's also no LESS safe. Both systems require that the trigger be pulled before the gun will fire, assuming that the thumb safety is OFF and the grip safety is depressed.
The Series 80 passive firing pin block only renders the gun more drop-safe.
All else is equal. Bottom line: It's a GUN. It's NOT safe.